Vail-60S 10’ x 10’ Single-Sided Graphic Package. Vail-60S is a double-sided Resort Extrusion with a 60mm wide profile. This extrusion has a solid outside finish. Because the profile width is so thick, VAIL-60S is especially good for free-standing large images (tall or wide) because it is more stable than the skinnier profile widths; however, it can be wall mounted or hung overhead. When installing the fabric graphic, the keter can fit 12mm deep and 3mm wide into the keter trough. This extrusion is not compatible with lights (cannot be backlit).
- (1) 4-Sided Frame
- (1) Custom Single-Sided Graphic (SEG hem)
- (4) VAIL Corner Connectors, (16) Socket Screws, (1) 3mm Allen Wrench
- (5) VAIL Split Connectors (1 pre-installed on 1 VAIL-40C), (1) Torx Key
- (2) VAIL Key Locks (pre-installed), (1) 4mm Allen Wrench
- (2) VAIL-40C Support Extrusions
Suggested Uses: Retail Stores, Restaurants, Art Galleries, Grand Openings, Trade Shows, Offices, Showrooms, Backdrop, Photo-ops, Partition Wall, Step & Repeat, Etc.
Material: Deco Fabric (non-stretch)
Print Process: Full Color Dye Sublimation
Hardware Setup: : To make one edge of the frame, take two cut VAIL-60S extrusions and, between, add Split Connector; tighten. Repeat this twice. Take one completed 10’ edge and one 10’ edge and slide in Corner Connector; tighten. Repeat this three times. Vertically insert ends of VAIL-40C into top and bottom of the frame; tighten.
Upgrade to Replace: VAIL Toolless Corner Connector and VAIL Split Connectors
Graphic Installation: Transversely, push corners of graphic into the frame’s recessed groove. Then, starting midway on the frame going toward the corners, continue pushing in the straight edges of the graphic on all four sides.
Accessories (sold separately): Wall Mounts, Ceiling Eye Hooks, Steel Base, Whistler Feet, Yeti Feet.
Warranty: Lifetime on frame; one (1) year on graphics
Frame Size: 108″W x 120″H x 3.94″D
Artwork Size: 110″W x 38″H
Shipping Dimensions: (2) boxes 73.25″L x 7.25″W x 6.5″H & 49.75″L x 7.25″W x 6.5″H